Camouflage & Single Color Polymax Firearm Finishes
The technicians at The Robar Companies, Inc. have developed a procedure to apply a polymer coating to firearms. POLYMAX can be applied to steel, stainless steel, and aluminum surfaces. POLYMAX camouflage finish is available in Woodland, Urban and Desert (3 or 5 color) patterns. POLYMAX camouflage can be applied to the entire firearm including stock and bipod, the stock only, or in any combination. Robar can also do custom patterns or a single color such as tan or green if that's what you want. POLYMAX offers a number of advantages: Chemical Resistant, Water Resistant, Excellent Adhesion, Mar & Abrasion Resistant, Excellent Hardness, Great Impact Resistance, Custom Colors & Camouflage Available.
Performance Tests on 1 Mil Dry Film: Polymax
-
5% Salt Spray - 1000 hours - no failure
-
Pencil Hardness...2H
-
Solvent and Chemical Resistant
-
100% Relative Humidity - 500 hours - no failure
-
Water immersion - 100 hours - no failure
-
Lubricating oil, hydraulic fluids and cutting oils, excellent resistance
-
Cold Check: 16 cycles; 24 hours @ 100% humidity; 24 hours @ 10 degrees Fahrenheit, 24 hours @ 77 degrees Fahrenheit.
-
Taber abrasion - CS 17 wheel, 1000 gm load; <100 mg. loss in 1000 cycles
-
Impact resistance: Forward 100 inch pounds. Reverse 80 inch pounds
Computers, monitors and web browsers all render colors slightly differently. While we have attempted to show the colors of our finishes as accurately as possible, there is a good chance that the actual color of the finish will be slightly different than what you see on your screen. Also, scopes must be completely disassembled and only the metal parts sent in for coating - Robar cannot refinish assembled scopes and does not disassemble / reassemble scopes.
